DIY Christmas Cards and Envelope Liners: A Handmade Set to Send This Season
A card in the mailbox that someone made by hand feels different from a store-bought one. It takes a few minutes of paper, glue and a steady hand, and it tells the person on the other end that they were worth the time. This guide walks through three simple Christmas card designs, a patterned liner you can add to any envelope, and a wax seal to finish it all off.
I’m sharing the three designs I’d start with: a cut-paper tree, a stamped holly sprig, and a green and cream card with a wax seal. If you only have time for one, I’d pick the paper tree, since the layering and gluing it teaches carry over to the other two. Everything here uses basic paper supplies, so a full set is an afternoon project.
This post contains affiliate links. As an Amazon Associate, I earn from qualifying purchases at no extra cost to you. Content on Life With Amanda is created with the help of AI.
What You Will Need
- Blank folded cards with envelopes: cream A2 cards (about 4.25 by 5.5 inches) with matching envelopes. A light envelope color lets the liner paper stand out.
- Burgundy red cardstock: heavyweight 80 lb paper in a deep cranberry shade for the front panel of the tree card.
- Dark green cardstock: a forest green shade for the second layer of the tree and the front panel of the wax seal card.
- Christmas plaid scrapbook paper: a pad of 12 by 12 inch double-sided red and green plaids for the envelope liners.
- Double-sided tape: thin, clear tape gives the flattest finish and will not wrinkle the paper.
- Holly clear stamp set: a clear stamp set with a holly sprig, pinecones and a few small greenery designs.
- Green ink pad: an archival pigment ink pad in deep green for the stamped holly card.
- Wax seal kit: a brass seal stamp with sealing wax beads, a melting spoon and a tealight candle, in red, green and gold.
- Gold gel pens: a metallic set that includes gold, plus silver and white, for berries, ornaments and short greetings.
- Precision craft scissors: small, sharp scissors with a fine tip for cutting the tree tiers cleanly.
- Natural jute twine: for wrapping a card under its wax seal and for tying a finished set together.
- A pencil and a ruler: for tracing templates and measuring panels.
Before You Start: Plan Your Set
Choose your colors first. Cranberry, forest green, cream and a little gold look classic together, and sticking to that palette makes three different cards feel like one set. Lay your papers side by side and decide which card gets which color before you cut anything.
Use heavyweight paper for the pieces you will glue. Cardstock holds a crisp edge and stays flat, while thin patterned paper is better saved for the envelope liners.
Test your tape or glue on a scrap before you start. Too much wet glue can wrinkle thin paper, so a thin line of double-sided tape is the safer choice for most of these projects.
Card 1: Cut-Paper Christmas Tree

This card is made from simple layers. A cream tree sits on a cranberry panel, with a smaller green tree on top and a few gold details to finish it.
- Make the panel: cut a rectangle of cranberry cardstock about 4 by 5 1/4 inches and tape it to the front of a cream folded card, leaving a thin cream border all the way around.
- Draw a template: sketch a tree on scrap paper with three stepped tiers, about 3 inches tall and 2 1/2 inches wide at the base, and cut it out.
- Cut the trees: trace the template onto cream cardstock and cut it out. Trace it again on forest green cardstock, then trim about 1/4 inch off the outside edge so the green tree is slightly smaller.
- Layer the tree: tape the green tree onto the cream tree, centered, so a thin cream edge shows all the way around.
- Add a trunk: cut a small rectangle from a scrap of cardstock and tape it under the bottom tier.
- Attach it to the card: press the finished tree onto the center of the cranberry panel, a little above the bottom edge.
- Add the details: dot a few ornaments on the tree with the gold gel pen and draw a small star at the top.
Card 2: Stamped Holly Sprig

A stamped card is the quickest of the three, and it looks best when you keep the design small and leave plenty of white space.
- Test the stamp: press it on scrap paper first to see how much ink you need and where it prints best.
- Ink the stamp: tap the stamp onto the green ink pad a few times until the whole design is evenly covered.
- Stamp the card: choose the lower left corner of a plain cream card, press the stamp straight down for a couple of seconds, then lift it straight up so the image does not smear.
- Let the ink dry: leave the card flat for a few minutes before you touch it. Pigment ink takes longer to dry than most people expect.
- Add the berries: dot small gold berries near the holly leaves with the gel pen.
- Add a strip of color: tape a thin strip of cranberry cardstock down the fold for a simple accent, if you like.
- Write inside: add a short greeting with the gold gel pen once the front is dry.
Card 3: Green and Cream Card With a Wax Seal

This card is quiet and elegant. A single wax seal is the only decoration, which makes it a good one to send to someone you want to impress.
- Make the base panel: cut a rectangle of forest green cardstock about 4 by 5 1/4 inches and tape it to the front of a cream folded card.
- Add a cream panel: cut a smaller cream rectangle, about 3 by 4 inches, and tape it in the center of the green panel.
- Add twine, if you like: wrap a length of jute twine once around the card across the lower part of the cream panel and tie it, so the seal can sit over the knot.
- Set up a safe space: work on a heat-safe surface, such as a ceramic tile, and keep the wax away from the card until you are ready to seal.
- Melt the wax: follow the directions that come with your kit, since melting methods and times vary by brand.
- Place the wax: drop a small pool of melted wax onto the bottom center of the cream panel, over the twine knot if you used one.
- Press the stamp: press the seal stamp into the wax, hold it still for a few seconds, then lift it straight up.
- Let it cool: leave the card flat until the wax has fully hardened before you move it.
Melted wax is hot, so keep the work area clear of children and pets, and never leave a flame or heating element unattended.
How to Make a Patterned Envelope Liner

A liner is the small detail that makes someone smile when they open the envelope. Plan on one liner per envelope, and make a test one on scrap paper first.
- Trace the envelope: open the flap and lay the envelope on the back of a sheet of patterned paper with the flap pointing up. Trace around the flap and the top edge of the envelope body.
- Cut inside the line: cut about 1/8 inch inside the traced line so the liner will fit without bunching.
- Crease the fold: fold the liner along the line where the flap meets the envelope body, so it bends the same way the envelope does.
- Test the fit: slide the liner into the envelope and check that it sits flat against the inside of the flap and the back.
- Tape the flap: stick a strip of double-sided tape across the back of the flap portion of the liner and press it onto the inside of the flap.
- Secure the body: add a small piece of tape along the top edge of the body portion so it does not slide out.
Mailing Your Cards
Standard-size cards in standard-size envelopes are the easiest to mail. If you have a square card, a thick card or a card with raised pieces, check the postage rules with your local post office before you buy stamps, because some shapes and thicknesses cost more.
A raised wax seal on the outside of an envelope can catch in sorting machines. Many people press the seal onto the card itself, or use a flat self-adhesive wax seal sticker on the flap instead. Write the address in clear, dark ink, and let any wet ink or wax dry completely before the card goes into the mail.
Packaging a Set as a Gift

A set of three cards, one of each design, makes a thoughtful small gift. Slip each card into its lined envelope, stack them, and tie the bundle with jute twine. You can add a short handwritten note or a gift tag on top, or tuck the set into a small box for a teacher, a neighbor or a friend who still loves getting real mail.
Tips and Troubleshooting
- If the tree edges look rough: trim them with sharp scissors and move the paper as you cut, not the scissors, for a smoother curve.
- If the paper wrinkles: you probably used too much glue, so switch to double-sided tape, which stays flat.
- If the stamp prints unevenly: press with even pressure, and try a flat, firm surface under the card instead of a soft one.
- If the ink smudges: wait longer before touching the card, or stamp on a scrap first to see how much ink you need.
- If the wax seal cracks: it usually means the wax cooled too fast or the paper moved, so let it set undisturbed next time.
- If the liner will not fit: trim a little more off the edges, since a snug liner is easier to slide in than a tight one.
Keep the Handmade Christmas Going
If you are making things for everyone on your list, these handmade Christmas gift ideas are a good next read, and the DIY teacher gift baskets give you a pretty place to tuck a card. I can’t wait to see how yours turn out.